- Connection failed - Fixed issue where the desktop would specify that the main beam had been modified between buttons 1 and 2.
- Two-sided single angle connection to sloped girder
- 1. “Rotation” of filler beam limitations, for single angle, double angle and shear plate connectionshould be maximum from vertical of 1:12 (4.76 degrees rotation). This one shown below is toomuch. Should be kicked out with error message saying “Filler beam rotations greater than 1:12 slope from vertical not yet functional in Qnect.”
- “Rotation” of girder can be whatever is in the model, though as stated above, filler beam should be limited to 1:12 (4.76 degrees).
.png?width=276&height=263&name=QNT-8495%20(2).png)
- 2. Double angle rotated filler connections not connecting, but should.
.png?width=825&height=342&name=QNT-8495%20(3).png)
- 1. “Rotation” of filler beam limitations, for single angle, double angle and shear plate connectionshould be maximum from vertical of 1:12 (4.76 degrees rotation). This one shown below is toomuch. Should be kicked out with error message saying “Filler beam rotations greater than 1:12 slope from vertical not yet functional in Qnect.”
