1 min read

Release Notes: March 2025

Picture of Jeff Hausthor Jeff Hausthor : May 20, 2025 11:46:04 AM

Tech Tuesday Product QuickQnect Software AEC Industry update

QuickQnect / Tekla Specific Enhancements

Bolts clashing with Shear Plate in column web - In certain instances an erection issue was occurring with a Double Angle on column flange and a shear plate on column web. This has been resolved.

Web-environment: issue with tables: unable to scroll, unable to copy and paste rows - The scroll bar on the mandated preferences pages was not operating properly. This has been resolved.

Clean-up profiles drop down lists sort and values (forces page ONLY) - this was done for HSS as a secondary
Issue with CJP welds preps on Moment Connections with CISC building codes has been resolved.
End Plate connections have incorrect cost data for bolts. This has been resolved.
HSS tnom vs tdes
- 1. This preference will be removed from the web pages and therefore should no longer be used by the engineering app.
- For connections to an HSS support and for HSS filler beams with CSA G40.21 or A1085 material, can Qnect use tnom instead of tdes when checking strength limit states?
  - ()Yes ()No
- 2. In the new solution, the app is expected to always use “tnom” value and name with A1085 and CSA G40.21 (350W) HSS material grades.
- 3. This note on sample calculations for A1085 material
- ”Using tnom per user preferences for A1085 material” should be changed to “Using tnom for A1085 material” and this note for G40.21 (350W) material
- “Using tnom per user preferences for G40.21 material” changed to “Using tnom for G40.21 (350W) material”

Show new fields on Mandated shear plate preferences to meet customer requirements

When No Connection overwrites red connection it changes the loads back to the original load. It has been changed to keep any loads entered in the UDA by the user.
Update CISC moment and axial flags = ON in all environments - CISC moment connections and moment connections with axial has been turned on.

1 min read

Jeff Hausthor : Aug 7, 2025 1:54:25 PM

Make 1/8 clip on shear plate Optional Qnect for Tekla 2025 - The Tekla installation now works for 2025. Fix vertical bolt spacing when optional...

Tech Tuesday Product QuickQnect Software AEC Industry update

Jeff Hausthor : May 20, 2025 11:43:21 AM

QuickQnect / Tekla Specific Enhancements

Tech Tuesday Product QuickQnect Software AEC Industry update

Jeff Hausthor : Feb 3, 2025 1:43:15 PM

QuickQnect / Tekla Specific Enhancements Connection Error - An error arose where a group with 4 Beam to HSS Column all were connected. Then one...

Tech Tuesday Product QuickQnect Software AEC Industry update