Jeff Hausthor
Release Notes: October 2024 | Qnect
Jeff Hausthor : Jan 22, 2025 1:18:00 PM
Add more setback preferences at column web framing condition
- Get report data for Connection Engineer - Enhancement for in-model-review tool.
- In model review tool - report to be based on GUID
- Top Elevation for In model review tool
- Span change of secondary ignored for duplicate check if not using UDL. So when a change is made to the span with a cut or a small move, we will ignore that change if the force was not calculated with UDL (otherwise the span change changes the force), so when we re-engineer , the customer is more likely to receive the same connection code.
- Qnect Station Fabrication - ability to identify if each beam uses two station or one station fabrication. (see below)
- Change side of a CJP weld prep at Shear Plate to Column Web connection - Beam to Column Web Extended Shear Plate connection should always have CJP weld prep facing the beam web.
- VBSA - Adjust gage at angle legs <5"
- For in-plane angle legs >= 5” we will continue to use Table 1-7A for gage to bolt from heel as we do today: gage = max(standard gage “g” from Table 1-7A, min edge dist, kdet + c3, thickness + c1)
- For in-plane angle legs < 5” we will update to use the following formula for gage to bolt from heel. For example with 0.75 bolts as currently done in 4x4 shown below= 2.5, update to:
- gage = max(0.5 * in-plane edge, min edge dist, kdet + c3, thickness + c1) =max(0.5*4, 1.0, 0.75+0.75, 0.375+1.1875) = 2.
- Remove support for Tekla 21.1 & 2016i
- Set to Extended Shear Plate when need doubler and setback at beam is near support flange toe - This occurs at skewed beam to beam Shear Plate connections.
- There are cases when a skewed beam has a setback distance such that the end of beam is near a flange toe (as shown on the picture). Currently in such cases we switch to EXTENDED setback Shear Plate connection. We modified this condition to only switch to EXTENDED setback if a beam needs reinforcement (doubler) plate and is 1 in. (25 mm) in orthogonal direction from support girder flange toe.
- There are cases when a skewed beam has a setback distance such that the end of beam is near a flange toe (as shown on the picture). Currently in such cases we switch to EXTENDED setback Shear Plate connection. We modified this condition to only switch to EXTENDED setback if a beam needs reinforcement (doubler) plate and is 1 in. (25 mm) in orthogonal direction from support girder flange toe.
Release Notes: February 2020
Jeff Hausthor : Mar 14, 2020 3:45:00 PM
After the holiday rest, we had a productive and, I’ll say, exciting time on the product development side of the house. Most of the enhancements are...
QuickQnect® Release Notes: March 2023
Jeff Hausthor : Apr 24, 2023 10:58:13 AM
Add user_id (email address) to the User Admin page when seeing the list of names